|
Infrared Probe
Line Driver
Carrier Current/Video Probe
|
|
|
If you suspect your premises are bugged, for your own peace of mind,
check it out. The Advanced Bug Detector can be used to detect, verify
and locate hidden transmitters in your home, office or car. Use the
Advanced Bug Detector to perform a professional RF sweep of your
premises, including your telephone system. Similar in operation to a
Geiger counter, the sensitive antenna system can be used to probe all
areas of a room. As the antenna approaches the hidden transmitter, the
audible tone clicks faster and faster while the ten step solid-state
meter indicates the signal strength. At this point, switch modes from
Detect to Verify to differentiate a bug from a regular radio or TV
transmission. If a bugging device is present, a continuous squealing
tone is generated by the Advanced Bug Detector. By sweeping the probe,
this tone can lead you directly to the bug. The switch selectable
SENSITIVITY level improves detection capabilities of the unit in high
signal strength areas. For private (non-alerting) listening, an earphone
jack is provided. Included with the
Advanced Bug Detector is the wideband active probe which covers 5 MHz to
2,500 MHz. It can be positioned up to 25 feet away from the Advanced Bug
Detector by using an extension cable. For example, the probe could be
discreetly placed in a target room while t he Advanced Bug Detector is
monitored in another room. Several other plug-in probes are available
which will extend the usefulness of your Advanced Bug Detector (see
below). The unit measures 5.8" x 3.4 x 2" (with cover closed) and
weights 9 oz. It is powered by one 9 volt alkaline battery (included).
Also included is an illustrated instruction manual. |
|
BD213
Advanced Bug Detector $439.99
BD02
Infrared Probe $89.99
BD03 Line Driver $99.99
BD04 Carrier Current/Video
Camera Probe $249.99 |
|
Options:
IR
(infrared probe) BD02: Light beams, especially lasers, provide an
excellent method for carrying audio intelligence and are not detectable
by RF detectors. The BD02 is a special probe which allows you to search
for sources of infrared transmissions. In the case of amplitude
modulated or pulse frequency modulated sources, you can actually listen
and determine if the IR beam is carrying voice or other intelligence.
LINE
DRIVER BD03: The BD03 Line Driver probe lets you use the BD213 for
checking suspicious wire pairs for hidden microphones. One of the two
LEDs on the BD03 alerts you to the presence of voltage on a wire pair.
The other LED alerts you to current flow in a wire when the line driver
switch is operated. The line driver switch applies a voltage to the wire
pair under test to turn on voltage activated microphones. The A/B switch
reverses polarity for detecting polarity sensitive devices. You can also
monitor the wire pair through the BD213 amplifier and speaker to
determine if room audio is present on a wire pair. Any of the above
conditions can indicate a microphone attached to the wire pair under
test.
The BD04
is used in conjunction with the BD213 for detecting carrier current
transmitters and hidden video cameras. Examples of carrier current
transmitters are the wireless intercoms and room monitors sold in many
electronics stores and catalogs. Carrier current eavesdropping devices
can be connected to power lines, phone lines of other wire pairs. The
probe covers from 10 KHz to 600 KHz in two ranges. It uses a directional
pickup loop and no connection to the power lines or other wires under
test is necessary. Any demodulated audio can be monitored and verified.
|
|
